Do you know the basic operation method of 3F pneumatic cable stripping machine?

Do you know the basic operation method of 3F pneumatic cable stripping machine?

Operation method of 3F pneumatic cable stripping machine:

1, the air inlet pipe connecting the air supply 4.5-7kg/ 2 cm

2, the power cord plug into the 220V 50Hz power supply  ‘

3, the foot switch to make the cylinder action

4, as shown in Figure two, trimming operation key: loosen the nut in middle of headless screw,nut 1 control upper clamp block up and bottom; nut 2 control knife mold up and bottom, with different thickness of wire, the nut turn up (counterclockwise) is tight, turn down (clockwise) is loose.

5, debugging well then locking the headless screws,main cylinder on the tail is pulling wire cylinder,stroke adjust screw is used for adjusting stroke of cylinder, forward is shorter stroke (such as half stripping) backward is longer stroke, wire stripping adjusting ok then fix nut lock. The two regulating valves before and after the cylinder respectively are adjusting for stripping and speed of return, the speed should be moderate to normal use.

6, the use of double-cutters machine model is the basically same as above, design for the wire cut and strip in one time.

Need to pay attention to the following points:

A) without gasket, the gap between cutter and stripping blade is 1.5mm.

B) increase or decrease gasket should pay attention to the upper and lower thickness must be compatible in case collision and damage of cutter.

C) according to the length of wire stripping to increase or decrease gasket , such as peeling 3.0mm, put on a pair of 1.5mm gasket, that is 1.5+1.5=3.0mm.

D) cutter will be removed for stripping longer, you can use a single knife, peeling length is decided by block.

The function and application of 3F Pneumatic Cable Stripping Machine:

1, This cable stripping machine is specialized in some special wire processing in wire harness processing industry, such as: multi-core cable, sheath cable, shield cable,telephone cable, flat cable and so on small gauge wires.General wire diameter AWG # 18-32, the diameter 0.5mm above special cables can be used on this machine.

2, The improvement of core wire stripping with foot and hand-drawing mode of traditional computer, turned into a pre-clipping and rear-reversing mode, save energy, and improve the efficiency of the best type.

3, The operation of the plane and move around the way out, to shorten the blade and clamp and make the short strip wire such as the common type cannot be peeled from the use of this machine, and no fears of injury or burn your fingers.

4, Another double blade design, stripping and cutting off one time, the gasket to increase or decrease of fixed-length, accurate, rapid, blowing device can automatically clear the debris after stripping.